The Cost. Hardie board siding runs about $0.70 to $5.25 per square foot.
Vinyl siding is cheap, ranking among one of the least expensive ways to side your home. Many homeowners are happy with the look of vinyl siding. Vinyl's look is improving, too, with technological advancements in texture and colorfastness. You can also paint it if you want.
You can expect to pay between $3 and $8 per square foot for vertical vinyl siding (including installation). Horizontal vinyl siding will cost a bit less — $2 to $6 per square foot — as it requires less labor to install.
An average 1,500 square foot house would cost around $7,700 for standard aluminum siding and upwards of $11,000 for custom grades after labor and material costs.
It takes more labor and more time to install brick veneer siding than it does hardi plank, thus making the brick significantly more expensive when comparing on a square footage basis.
It can be expensive – Board and batten can also be more expensive than other styles, mainly because of the extensive installation process. The installation needs to be completed very carefully, which causes it to take longer than other types of siding.
Homeowners usually pay between $5,400 and $15,500 to side a house, or about $10,300 on average. *These prices are for a typical single-family home that ranges from 1,500 to 2,500 square feet.
Paint. Needs to be done about every five years, or as soon as you see it deteriorate. A DIY paint job requires about 60 hours of labor.
How many Hardie planks do I need? Divide the linear footage by 12′ to find the number of boards needed to cover the wall. For example, installing 21 courses of siding on a 20′ wide wall will require 420 linear feet of siding, or 35 boards.
HardiePlank Lap Siding CostHardiePlank lap siding costs $0.70 to $6 per square foot for materials. With labor, equipment and trim, you'll pay $5 to $14 per square foot for installation.
You'll only want to use enough nails to secure the lattice strips to the wall. Be careful not to overdo the nails because you'll have to patch all of those holes before painting. When the horizontal boards were in place, it was time to put up the vertical battens.
Wainscoting is a protective barrier applied to the lower half or lower third of a room, usually on all the walls. Board and batten refers to a specific design that can be used to create this protective barrier.
Typically, batten are spaced anywhere from 12†to 24†apart. I think it looks best to space them as close to 18†as possible, but that's just a personal preference. Our wall is 164†wide, so we used 8 batten (for a total of 7 spaces) with a distance of 19.42 inches between each batten.
Use paintable caulk to fill the gaps between the wall and all board edges. This will take time, but it's how you end up with a professional-looking end result! Fill your nail holes and go over everything with a sanding block and/or sander.
A true batten is 2-inches in width or smaller, but you can use larger widths by installing trim in place of a batten if you want a thicker appearance. They're installed directly over the vertical panels to get the traditional look.
Shiplap, used indoors or out, introduces texture to rooms. You could just try painting interior doors to give your home a little oomph, but board and batten is a way to give a room—or a whole house—an upgrade that feels a little more custom.
Board-and-batten can be installed onto solid plywood or OSB sheathing. If your sheathing is not solid, you will need to first attach horizontal furring strips. With a helper, expect to spend a day installing 800 square feet of siding.
Cedar is a common choice for exterior board and batten siding, but other acceptable wood species include Cyprus, redwood, locust, white oak, and hemlock.
